Why does injection water quality matter?
Injection water is expected to meet specific quality standards before it is introduced into the formation. For sulphate removal unit applications, Pall filtration solutions also support the production of low-sulphate water for injection.
In injection water and sulphate removal unit applications, Pall liquid particle filters remove contaminant particles from the fluid stream. Without effective particle control, contamination can contribute to injection and disposal well plugging or environmental violations, as well as excessive pump wear, heat exchanger fouling and contactor foaming. Managing injection water quality is therefore an important part of maintaining well performance.
How does waterflood injection support oil recovery?
After natural reservoir pressure declines, waterflood injection can repressurize the formation and help sweep oil toward producing wells. Primary production can recover about 30% of the original oil in place. Secondary production using waterflood injection can increase recovery to approximately 60%.
How readily the injected water moves through the porous rock depends on formation permeability. In tighter formations, the smaller spaces between rock granules can trap fine particles carried by the injection water. As these solids accumulate, injection becomes more difficult and oil production can decline.
Re-establishing flow may then require a workover or stimulation. These operations can cost millions of dollars, require the well to be taken offline and may not fully recover the damage.
How clean should injection water be?
A commonly used rule of thumb links the required filtration level to formation permeability: injection water should be filtered to a micron level equal to 1/3 to 1/7 of the square root of permeability measured in milliDarcys.
Under this guidance, injection water for a 100 milliDarcy formation would be filtered to between 1.4 and 3 microns. The calculation is a rule of thumb rather than a universal specification.
Which filtration options support injection water treatment?
Achieving fine injection water cleanliness levels requires high-efficiency filtration. Pall absolute/Beta-rated filters are suited to these requirements, while nominally rated or absolute-rated filters are available for coarser formations.Depending on formation permeability and existing equipment, filtration options include:
- Absolute/Beta-rated filtration for fine injection water cleanliness requirements
- Nominally rated or absolute-rated filtration for coarser formations
- Complete injection water filtration solutions
- Retrofit filter elements for existing equipment configurations
Depending on the filtration equipment already in place, Pall can provide complete injection water filtration solutions or retrofit filter elements.
How does the Ultipleat High Flow Filter support high flow applications?
For high-flow applications, the Ultipleat® High Flow filter combines a large-diameter, coreless, single-open-ended pleated cartridge with an inside-to-outside flow pattern. Its crescent-shaped pleat geometry, 152.4 mm (6 inch) diameter and range of Pall filter media allow fewer filters and smaller housings to be used.
Systems can handle up to 115,443 lpm (30,500 gpm). Depending on the equipment already available, Pall provides complete injection water filtration solutions or retrofit element styles.
Liquid/Liquid Coalescers - Liquid Separation and Particle Removal
Liquid/Liquid Coalescers - Liquid Separation and Particle Removal.
Talk to an injection water filtration expert
Contact the Pall filtration team to discuss injection water quality, sulphate removal and the appropriate filtration configuration for current equipment needs.